Lincoln Electric Welder US CW139 User Manual

US-CW139  
3/7/2008  
Date:  
MSDS No.:  
Innershield NR-208 Special  
All  
Trade Name:  
Sizes:  
3/29/00  
Supersedes:  
M A T E R I A L S A F E T Y D A T A S H E E T  
For Welding Consumables and Related Products  
Conforms to Hazard Communication Standard 29CFR 1910.1200 Rev. October 1988  
SECTION I - IDENTIFICATION  
Manufacturer/  
Supplier:  
Product Type: Flux Cored Electrode  
The Lincoln Electric Company  
22801 St. Clair Avenue  
Cleveland, OH 44117-1199  
(216) 481-8100  
Classification: AWS E71T8-K6  
SECTION II - HAZARDOUS MATERIAL (1)  
I M P O R T A N T !  
This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal  
use of this product are covered by Section V; see it for industrial hygiene information.  
CAS Number shown is representative for the ingredients listed. All ingredients listed may not be present in all sizes.  
(1) The term “hazardous” in “Hazardous Materials” should be interpreted as a term required and defined in the Hazards Communication  
Standard and does not necessarily imply the existence of any hazard. All materials are listed on the TSCA inventory.  
TLV  
PEL  
Ingredients:  
Barium compounds (as Ba)*****  
Fluorides (as F)  
CAS No.  
513-77-9  
Wt.%  
5
< 5  
< 5  
< 5  
< 5  
1
mg/m3  
****  
2.5  
mg/m3  
****  
2.5  
7789-75-5  
65996-74-9  
7429-90-5  
7439-95-4  
7439-96-5  
7440-02-0  
554-13-2  
Iron oxides  
5
10  
Aluminum and/or aluminum alloys (as Al)*****  
Magnesium and/or magnesium alloys and compounds (as Mg)  
Manganese and/or manganese alloys and compounds (as Mn)*****  
Nickel (metal)*****  
10  
15  
10*  
0.2  
1.5  
10*  
5 (c)  
1
1
0.5  
Lithium compounds (as Li)  
10*  
5**  
10  
5
10*  
10*  
5**  
15  
5
10*  
Mineral silicates  
1332-58-7  
1317-65-3  
12004-83-0  
7440-21-3  
0.5  
Limestone and/or calcium carbonate  
Zirconium alloys and compounds (as Zr)  
Silicon and/or silicon alloys and compounds (as Si)  
< 0.5  
< 0.5  
< 0.5  
Carbon steel tube  
7439-89-6  
80  
10*  
10*  
Supplemental Information:  
(*)  
Not listed. Nuisance value maximum is 10 milligrams per cubic meter. (*****) Subject to the reporting requirements of Sections  
PEL value for iron oxide is 10 milligrams per cubic meter. TLV value  
for iron oxide is 5 milligrams per cubic meter.  
311, 312, and 313 of the Emergency Planning and  
Community Right-to-Know Act of 1986 and of  
40CFR 370 and 372.  
(**)  
As respirable dust.  
(c)  
Value is for manganese fume. Present PEL is 5  
milligrams per cubic meter (ceiling value). Values  
proposed by OSHA in 1989 were 1.0 milligrams per  
cubic meter TWA and 3.0 milligrams per cubic meter  
STEL (Short Term Exposure Limit).  
(****)  
There is no listed value for insoluble barium compounds. The TLV  
for soluble barium compounds is 0.5 mg/m3.  
SECTION III - HAZARD DATA  
Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See Z49.1 referenced in Section VI.  
Product is inert, no special handling or spill procedures required. Not regulated by DOT.  
Rev 9/07  
(CONTINUED ON SIDE TWO)  
 
 

Kustom Portable Speaker Ardent 12M User Manual
LG Electronics Washer Dryer WD 3274RHD User Manual
Lindy Network Card 51143 User Manual
Magnavox DVD Player mdv436 User Manual
Majestic Appliances Indoor Fireplace Majestic Oak Series User Manual
Makita Battery Charger DC1804 User Manual
Mattel Model Vehicle Y0276 User Manual
Mazda Automobile 2009 5 User Manual
McCulloch Trimmer MCT2027 User Manual
Memorex CRT Television MT2245 User Manual